184.108.40.206.1 Electronic equipment parts. Electronic equipment parts shall be
selected from MIL-STD-242, MIL-STD-1562 (microcircuits), MIL-STD-701
(semiconductors) and the Government Furnished Baseline (GFB) in order to
facilitate effective logistic support, improve quality, and reduce costs. The
GFB is intended to support the DOD Standardization and Parts Control Program
outlined in MIL-STD-965 by listing preferred parts for use in military
electronic and electrical systems. GFB parts lists are available from the
Military Parts Control Advisory Groups (MPCAG) of the Defense Logistics Agency
(DLA). MPCAGs may be contacted at the following
Defense Electronic Supply Center
Attn: Code DESC-EPE
1507 Wilmington Pike, Dayton, OH
Defense General Supply Center (DGSC)
South Jefferson Davis Highway, Richmond, VA
Defense Industrial Supply Center
Attn: Code ESM
700 Robbins Avenue, Philadelphia, PA
Defense Construction Supply Center
Attn: Code SS
Columbus, OH 43216-5000
220.127.116.11.1.1 Selected parts standards. Table X lists
parts that are described in MIL-STD-242.
18.104.22.168.1.2 Order of preference for parts selection. The order of
preference for parts selection shall be as shown in Table XI.
22.214.171.124.1.3 Suitability of electronic parts.
Suitability of electronic parts for an intended application shall be in
accordance with TE000-AB-GTP-010, MIL-STD-454, Table IX and as specified
126.96.36.199.2 Wire and cable. Aluminum wire shall not be used.
188.8.131.52.3 Air filters. Air filters shall be in accordance with MIL-F-16552.
184.108.40.206.4 Convenience power receptacles. Convenience power receptacles
shall not be provided.
220.127.116.11.5 Capacitors. Capacitors shall be in accordance with MIL-STD-198,
and as specified herein.
18.104.22.168.5.1 Electrolytic capacitors. Electrolytic (aluminum foil)
capacitors shall not be used in alternating current ac applications.
22.214.171.124.5.2 Paper capacitors. Paper or paper-plastic fixed capacitors with
nonmetallic cases shall not be used, except that nonmetallic-plastic wrapped
capacitors in accordance with MIL-C-55514 may be used in encapsulated or
hermetically sealed assemblies.
126.96.36.199.5.3 Paper dielectric capacitors. Fixed paper dielectric capacitors
shall not be used except as feed through radio interference capacitors, and
these shall be in accordance with MIL-C-11693.