The upper center of each page
shall be marked with the specification identifier and the word "APPENDIX"
followed by the appendix letter (for example, APPENDIX A) directly below the
identifier. If more than one appendix is needed, identification shall be
alphabetical (A, B, etc.).
The appendix title shall be located two
lines below the word "APPENDIX" on the beginning page only.
5.13.4 Section and paragraph numbering
The sections in
the appendix shall be designated by a letter corresponding to the appendix
letter, followed by a period and an Arabic numeral. For example, the
first section in Appendix A would be "A.1" and the second section in Appendix
B would be "B.2." Paragraphs and subparagraphs shall be numbered
consecutively within each section of the appendix. See Appendix A of
this document for example of paragraph
5.13.5 Table numbering
All tables shall be numbered
consecutively throughout an appendix. The word “TABLE” shall be in full
capitalization, followed by the applicable appendix letter, the Roman numeral
and a period, centered above the table. For example, the second table in
Appendix B would be numbered “TABLE B-II.”
5.13.6 Figure numbering
All figures shall be numbered
consecutively throughout an appendix. The word “FIGURE” shall be in full
capitalization, followed by the applicable appendix letter, the Arabic numeral
and a period, centered below the figure. For example, the fourth figure
in Appendix C would be numbered “FIGURE C-4.”
5.13.7 Page numbering
Page numbers shall be numbered
consecutively following the last page of the specification.
An appendix shall have a statement of
scope as its first paragraph to indicate the coverage and limitations of the
appendix to ensure its proper application and use. The following shall
be included: "This Appendix (is or is not) a mandatory part of the
specification. The information contained herein is intended for
(compliance or guidance only)."
References that are required and
relate only to the appendix shall be listed in the appendix under the section
heading "APPLICABLE DOCUMENTS" and shall not be referenced in section 2 of the
specification. The references shall be listed as specified in 5.7.
This section shall be omitted from the appendix if not applicable.
Definitions that relate only to the
appendix shall be listed in the appendix under the section heading
“DEFINITIONS.” Definitions already appearing in section 6 of the specification
shall not be repeated. This section shall be omitted from the appendix if not