A.1.1 Scope. This Appendix contains the format and content preparation
instructions for the Contractor's CM Plan required by paragraph 5.2.1. This
Appendix is a mandatory part of this standard. The information contained herein
is intended for compliance.
A.1.2 Applicability. The provisions of this Appendix apply whenever the
contractor is required to prepare a CM plan.
A.2 APPLICABLE DOCUMENTS
This section is not applicable to this Appendix.
A.3.1 Definitions used in this Appendix. For the purpose of this Appendix,
the definitions contained in Section 3 shall apply.
A.4 GENERAL REQUIREMENTS
A.4.1 Content and format instructions. The plan shall be prepared on bound 8
1/2 x 11 inch 20 pound copier paper (hard copy) or a form of electronic media as
specified in the contract. Each page prior to Section 1 shall be numbered in
lower-case roman numerals beginning with Page ii for the Table of Contents. Each
page from section 1 through the end of the document, shall be numbered
consecutively in Arabic numerals. For hard copy format, the document may be
printed on one or both sides of each page (single-sided/double-sided). For
single-sided documents, all pages shall contain the document control number in
the top right-hand corner. For double-sided documents, all even numbered pages
shall have the page number on the lower left-hand side of the document and all
odd-numbered pages shall have the page number on the lower right-hand side of
the document. For double-sided documents, the control number shall be placed in
the top right-hand corner for each odd-numbered page, and in the top left-hand
corner for each even-numbered page. All paragraph and subparagraph headings
listed in paragraph A.4.2 below shall be included in the plan. In the event that
a paragraph or subparagraph is tailored out, the following statement shall be
added directly following the heading: "This section (or paragraph or
subparagraph, as applicable) has been tailored out."
A.4.2 Organization of the document. The plan shall consist of the
A.4.2.1 Cover Page
A.4.2.2 Record of Reviews and History page
Table of Contents
A.4.2.4 Section 1. Introduction
A.4.2.5 Section 2.
A.4.2.6 Section 3. Organization
A.4.2.7 Section 4.
Configuration management phasing and milestones
A.4.2.8 Section 5. Data
A.4.2.9 Section 6. Configuration identification
Section 7. Interface management
A.4.2.11 Section 8. Configuration
A.4.2.12 Section 9. Configuration status accounting
Section 10. Configuration audits
A.4.2.14 Section 11. Subcontractor/vendor